keyboard break
2007-12-25 4:04:00
so far the only suggestion that worked, was to just use 'halt' at the command
line, as the other options did not work. I am using securecrt, but it could be
the keyboard set up that is the cause of my problem.
regards
-----Original Message-----
From: Chris Pinnock [mailto:cjep at NetBSD.org]
Sent: Wednesday, October 13, 2004 8:54 PM
To: Paul Clayton
Subject: Re: keyboard break
On Wed, Oct 13, 2004 at 03:06:52PM +0200, Paul Clayton wrote:
> This question should ilicit many response.
>
> I have a serial terminal. What key sequence to execute the break. I need to
> get into the ok> prompt.
>
It depends on the terminal application. If it is hyperterminal try CTRL-BREAK
or CTRL-SHIFT-BREAK.
Comments
Got something to say?
You must be logged in to post a comment.
