A1000 size problems
2007-12-25 0:34:00
I recently attached an A1000 (218GB) to an Ultra60 running solaris 2.6. I
did a probe-scsi-all and the drive was detected. However, when I using the
format command to display the partitions and the sizes . I am not seeing the
correct sizes. The / has 6k bytes , all the other partitions have 0
bytes. I did a boot -r no change resulted. I did not install the Raid
Manager software because the documents states the Array is already
preconfigured.
Any suggestions to overcome this problem ?
Acceptance of this message implies that you have read, and that you accept,
PETROTRIN's Email Disclaimer which can be found at
http://www.petrotrin.com/Email_disclaimer.htm
Comments
Got something to say?
You must be logged in to post a comment.
