Problems with cg6
2007-12-25 9:20:00
Thanks for response. Yes it was a silly idea to change the resolution
for the cg6.
Most of all told me that i can press L1 (Stop) n or enter the original
resolution at the prom prompt to reset the values and of course it works
(for me i entered the original resolution).
But, i'm someone who makes an error twice, what the solution if i do
the same error on a sparcstation 2 with a turbogx framebuffer and with a
multisync pc monitor connected, no solaris running but sparc linux.
I have tried all tips but the screen is black. I have tested the
monitor on another machine and it works. Could the framebuffer be
broken?
Thanks again
Wolfgang
My original question follows
> Hello.
> I have tested my cg6 framebuffer and entered following command in the
> Prom:
> setenv output-device screen:r1280x1024x72
> Than i have switched off the sparc 5 and turned it on again. The result
> was a black screen.
> I have tried some other commands but i could not reset the
> output-device.
> Are there any commands which i could reset the prom?
> Thanks in advance
> Wolfgang
--
Wolfgang Leideck * University of Mannheim * Dep. PI III
D7,27 * Raum 409 * D 68161 Mannheim
Phone: +49 621 292 8815 * Fax: +49 621 292 8818
Email: leideck@pi3.informatik.uni-mannheim.de
Comments
Got something to say?
You must be logged in to post a comment.
