SUMMARY: Sun 6130

2007-12-25 5:31:00

Two folks hit the nail on the head:

1. Julio Carrasco:

Document Audience: SPECTRUM
Document ID: 81921
Title: Sun StorEdge[TM] 6130: Overview of configuration via sscs for
Solaris data hosts
Copyright Notice: Copyright 2005 Sun Microsystems, Inc. All Rights
Reserved
Update Date: Wed Jul 13 00:00:00 MDT 2005
Products: Sun StorEdge 6130 Array, Sun StorEdge 6130 Array (SATA)

Keyword(s):6130, treefrog, configure, configuration, setup, install,
installation, sscs command

Step 4: Determine the WWNs of your initiators.

Get information about the host's HBAs by using luxadm -e:

# luxadm -e port

Found path to 2 HBA ports

/devices/ssm at 0,0/pci at 18,700000/SUNW,qlc at 1/fp at 0,0:devctl
CONNECTED
/devices/ssm at 0,0/pci at 18,700000/SUNW,qlc at 2/fp at 0,0:devctl
CONNECTED

# luxadm -e dump_map
/devices/ssm at 0,0/pci at 18,700000/SUNW,qlc at 1/fp at 0,0:devctl

Pos Port_ID Hard_Addr Port WWN Node WWN Type
0 10000 0 210000e08b18e328 200000e08b18e328 0x1f (Unknown
Type)
1 10200 0 50020f23000102d6 50020f20000102d6 0x0 (Disk
device)
2 103e4 100e4 50020f2300008c09 50020f2000008c09 0x0 (Disk
device)
3 10100 0 210000e08b18e429 200000e08b18e429 0x1f (Unknown
Type,Host Bus Adapter)

# luxadm -e dump_map
/devices/ssm at 0,0/pci at 18,700000/SUNW,qlc at 2/fp at 0,0:devctl

Pos Port_ID Hard_Addr Port WWN Node WWN Type
0 10000 0 210000e08b185c2a 200000e08b185c2a 0x1f (Unknown
Type)
1 10200 0 50020f230000ffd9 50020f200000ffd9 0x0 (Disk
device)
2 103e8 100e8 50020f2300008eec 50020f2000008eec 0x0 (Disk
device)
3 10100 0 210000e08b18b227 200000e08b18b227 0x1f (Unknown
Type,Host Bus Adapter)

2. Aaron Lineberger:

prtconf -vp | grep -i wwn

Original question:

When creating an initiator on a Sun 6130 disk array, which has several
systems connected, I see multiple wwn's that correspond to hba's. How do
I determine what wwn goes with which system? Using luxadm on any of the
systems connected I can find the card and get Firmware levels but I need
to be able to get the wwn from the card.

Comments

Got something to say?

You must be logged in to post a comment.