Next Problem caused by "serial console doesn't work and cause system die"
2007-12-25 2:00:00
Thanks for all your reply. I will summarize later because the problem is not
solved completedly.
As many people told, I hold down STOP-N after power on, the monitor can show
the banner now. But the next problem is,
it didn't go ahead, just hang on there. I tried to press STOP-A, there is no
response.
Thanks.
Jeremy
-----Original Message-----
From: Jeremy Jin @ Nucleus [mailto:jeremyjin at nucleus.com]
Sent: Tuesday, September 16, 2003 9:51 PM
To: codeprof at codeprof.com
Subject: serial console doesn't work and cause system die
Hello,
I tried to boot my Ultra 1 with serial console but now I got trouble.
What I did is,
in prom,
setenv output-device ttya
setenv input-device ttya
and then connect serial port A to a PC's serial port A, open a Windows 2000
hyper terminal,to try to boot the Ultra 1 from that serial console.
Unfortunately that doesn't work. I cannot see any message from either
monitor or the hyper terminal.
The computer is toally not able to boot up now!
What I tried next,
Open the box, find the NVRAM, and the plug it out, (I think it will flush
the content of it), but it didn't help.
I tried to find where is battery, but I failed to find one.
So sun managers, What can I do now?
Thanks very much.
Jeremy
Comments
Got something to say?
You must be logged in to post a comment.
