SUMMARY: FIRE280+A1000 needs too much boot time
2007-12-25 0:53:00
Two guys reported the same unsolved boot-time-extension.
No hint concerning the bad time stamp.
unamazed
NILS
-----
Hallo Listers,
I have the following Problem:
*machine: SunFIRE 280
*OS: Solaris 9, new installation
*A1000 + SCSI controller attached, no problem
*after installing RaidManager6.22.1 and
configuring the A1000 (12 x 36 GB) as RAID1 (one mirrored
drive, ca. 208 GB without hotspares etc.) I got the
following lines in /var/adm/messages at boot -r command:
!attend the weird timestamp at line 3-4 and the boot-time-extension
of ca. 8 minutes at 17:07:11!
!please look at the inserted '###'!
.
.
.
Mar 11 16:57:10 pi3 syslogd: going down on signal 15
###Mar 11 16:57:11 pi3 Array Monitor stopped
###Mar 11 17:07:54 pi3 RDAC support disabled
###Mar 11 17:07:55 pi3 Configuring the RAID devices
###Mar 11 16:58:32 pi3 genunix: [ID 540533 kern.notice] ^MSunOS Release
5.9 Version Generic_112233-03 64-bit
Mar 11 16:58:32 pi3 genunix: [ID 172905 kern.notice] Copyright 1983-2002
Sun Microsystems, Inc. All rights reserved.
Mar 11 16:58:32 pi3 Use is subject to license terms.
Mar 11 16:58:32 pi3 genunix: [ID 678236 kern.info] Ethernet address =
0:3:ba:12:eb:b9
Mar 11 16:58:32 pi3 krtld: [ID 469452 kern.info] NOTICE: sf: 64-bit
driver module not found
Mar 11 16:58:32 pi3 last message repeated 1 time
Mar 11 16:58:32 pi3 unix: [ID 389951 kern.info] mem = 2097152K (0x80000000)
Mar 11 16:58:32 pi3 unix: [ID 930857 kern.info] avail mem = 2040619008
Mar 11 16:58:32 pi3 rootnex: [ID 466748 kern.info] root nexus = Sun Fire
280R (UltraSPARC-III+)
Mar 11 16:58:32 pi3 rootnex: [ID 349649 kern.info] pcisch1 at root:
SAFARI 0x8 0x600000
Mar 11 16:58:32 pi3 genunix: [ID 936769 kern.info] pcisch1 is /pci at 8,600000
Mar 11 16:58:32 pi3 qlc: [ID 486054 kern.info] Qlogic FCA Driver v0.40.5
(0): F/W version 2.01.112
Mar 11 16:58:32 pi3 rootnex: [ID 349649 kern.info] pcisch0 at root:
SAFARI 0x8 0x700000
Mar 11 16:58:32 pi3 genunix: [ID 936769 kern.info] pcisch0 is /pci at 8,700000
Mar 11 16:58:33 pi3 qlc: [ID 686697 kern.info] NOTICE: Qlogic qlc(0):
Loop ONLINE
Mar 11 16:58:33 pi3 pcisch: [ID 370704 kern.info] PCI-device:
SUNW,qlc at 4, qlc0
Mar 11 16:58:33 pi3 genunix: [ID 936769 kern.info] qlc0 is
/pci at 8,600000/SUNW,qlc at 4
Mar 11 16:58:33 pi3 genunix: [ID 936769 kern.info] fp0 is
/pci at 8,600000/SUNW,qlc at 4/fp at 0,0
Mar 11 16:58:35 pi3 scsi: [ID 799468 kern.info] ssd0 at fp0: name
w21000004cf835dcd,0, bus address e8
Mar 11 16:58:35 pi3 genunix: [ID 936769 kern.info] ssd0 is
/pci at 8,600000/SUNW,qlc at 4/fp at 0,0/ssd at w21000004cf835dcd,0
Mar 11 16:58:35 pi3 scsi: [ID 799468 kern.info] ssd1 at fp0: name
w21000004cf78ed21,0, bus address ef
Mar 11 16:58:35 pi3 genunix: [ID 936769 kern.info] ssd1 is
/pci at 8,600000/SUNW,qlc at 4/fp at 0,0/ssd at w21000004cf78ed21,0
Mar 11 16:58:36 pi3 swapgeneric: [ID 308332 kern.info] root on
/pseudo/md at 0:0,0,blk fstype ufs
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 6 (glm0):
Mar 11 16:58:36 pi3 glm0 supports power management.
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 6 (glm0):
Mar 11 16:58:36 pi3 Rev. 7 Symbios 53c876 found.
Mar 11 16:58:36 pi3 pcisch: [ID 370704 kern.info] PCI-device: scsi at 6, glm0
Mar 11 16:58:36 pi3 genunix: [ID 936769 kern.info] glm0 is
/pci at 8,700000/scsi at 6
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 6,1
(glm1):
Mar 11 16:58:36 pi3 glm1 supports power management.
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 6,1
(glm1):
Mar 11 16:58:36 pi3 Rev. 7 Symbios 53c876 found.
Mar 11 16:58:36 pi3 pcisch: [ID 370704 kern.info] PCI-device: scsi at 6,1, glm1
Mar 11 16:58:36 pi3 genunix: [ID 936769 kern.info] glm1 is
/pci at 8,700000/scsi at 6,1
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 3 (glm2):
Mar 11 16:58:36 pi3 Rev. 5 Symbios 53c876 found.
Mar 11 16:58:36 pi3 pcisch: [ID 370704 kern.info] PCI-device: scsi at 3, glm2
Mar 11 16:58:36 pi3 genunix: [ID 936769 kern.info] glm2 is
/pci at 8,700000/scsi at 3
Mar 11 16:58:36 pi3 scsi: [ID 365881 kern.info] /pci at 8,700000/scsi at 3,1
(glm3):
Mar 11 16:58:36 pi3 Rev. 5 Symbios 53c876 found.
Mar 11 16:58:36 pi3 pcisch: [ID 370704 kern.info] PCI-device: scsi at 3,1, glm3
Mar 11 16:58:36 pi3 genunix: [ID 936769 kern.info] glm3 is
/pci at 8,700000/scsi at 3,1
Mar 11 16:58:36 pi3 scsi: [ID 193665 kern.info] sd30 at glm2: target 0 lun 0
Mar 11 16:58:36 pi3 genunix: [ID 936769 kern.info] sd30 is
/pci at 8,700000/scsi at 3/sd at 0,0
Mar 11 16:58:37 pi3 scsi: [ID 193665 kern.info] sd6 at glm0: target 6 lun 0
Mar 11 16:58:37 pi3 genunix: [ID 936769 kern.info] sd6 is
/pci at 8,700000/scsi at 6/sd at 6,0
###Mar 11 16:58:55 pi3 scsi: [ID 193665 kern.info] rdriver25 at
rdnexus1: target 0 lun 0
###Mar 11 16:58:55 pi3 genunix: [ID 936769 kern.info] rdriver25 is
/pseudo/rdnexus at 1/rdriver at 0,0
###Mar 11 17:07:11 pi3 pcisch: [ID 370704 kern.info] PCI-device: ebus at 5,
ebus0
###Mar 11 17:07:11 pi3 genunix: [ID 936769 kern.info] ebus0 is
/pci at 8,700000/ebus at 5
Mar 11 17:07:11 pi3 ebus: [ID 521012 kern.info] todds12870 at ebus0:
offset 1,300070
Mar 11 17:07:11 pi3 genunix: [ID 936769 kern.info] todds12870 is
/pci at 8,700000/ebus at 5/rtc at 1,300070
Mar 11 17:07:12 pi3 rootnex: [ID 349649 kern.info] mc-us30 at root:
SAFARI 0x0 0x400000 ...
Mar 11 17:07:12 pi3 genunix: [ID 936769 kern.info] mc-us30 is
/memory-controller at 0,400000
Mar 11 17:07:12 pi3 ebus: [ID 521012 kern.info] se0 at ebus0: offset
1,400000
Mar 11 17:07:12 pi3 genunix: [ID 936769 kern.info] se0 is
/pci at 8,700000/ebus at 5/serial at 1,400000
Mar 11 17:07:13 pi3 unix: [ID 987524 kern.info] cpu0:
SUNW,UltraSPARC-III+ (upaid 0 impl 0x15 ver 0x22 clock 900 MHz)
Mar 11 17:07:13 pi3 pcisch: [ID 370704 kern.info] PCI-device: usb at 5,3, ohci0
Mar 11 17:07:13 pi3 genunix: [ID 936769 kern.info] ohci0 is
/pci at 8,700000/usb at 5,3
Mar 11 17:07:14 pi3 ebus: [ID 521012 kern.info] su0 at ebus0: offset
1,3062f8
.
.
.
I'm curious if someone knows such a thing. How can I manage these
problems and shorten the boot-time?
Many thanks in advance
NILS
Comments
Got something to say?
You must be logged in to post a comment.
